Pair of universal chromed handlebars, low rise

Not suitable for V65 GT, Mille GT or other models with wide handlebar clamps. Note wide spacing of knurled sections sits outside handlebar clamps on T3, V50 etc... - see dimensions if in doubt about suitability for your bike

 1 in stock

Tool for clutch centre gear nut

Half inch socket drive. This is a cheaper aftermarket tool- see TOA14903 for original factory item

 This part is due back in stock soon, call 01484 841395 to reserve yours

 14912603 GU14912603 14 91 26 03
 1491 2603 1491.2603 14.91.26.03

Plastic inlet manifold, replaces unavailable aluminium manifold. Suitable for PHF 30 carb conversions on models previously fitted with VHB30 carbs. Contains inlet manifold, gasket, O rings, clip and M6 bolts to secure to head. Carb mounts direct to this manifold (no inlet manifold rubber required)

Note that on models with M8 inlet manifold bolts and standard heads (T3, 1000 SP) it will be necessary to drill out the manifold bolt holes from 6mm to 8mm to reuse your existing bolts. Can be used to replace PHF30 inlet manifolds 17116265 and 17116365 which are no longer available. These manifolds exit the heads at a different angle to VHB manifolds and in some cases you may need to modify side panels to allow clearance for air filters

 This part is due back in stock soon, call 01484 841395 to reserve yours

Front indicator bracket, bolts to rear of lower yoke

Can also be fitted to 850T, T3, T4, G5, Convert, 1000 SP, S3, Le Mans 2, Mille GT (35mm fork)

 Availability varies on this part, check availability

 63751321 GU63751321 63 75 13 21
 6375 1321 6375.1321 63.75.13.21

Front left hand brake pipe linking caliper to rigid pipe under fuel tank

Original type rubber brakeline with chunky galvanized ends

 This part is available by special order, request a quote

14658851-z 14658851 GU14658851 14 65 88 51
 1465 8851 1465.8851 14.65.88.51

Gudgeon Pin

Superceded by ENA28260, aways replace as a pair if fitting in place of this earlier pin 13061260 as later type is heavier

 Sorry, this part is no longer available.

 13061260 GU13061260 13 06 12 60
 1306 1260 1306.1260 13.06.12.60

Tacho drive pinion

 This part is available by special order, request a quote

 14769200 GU14769200 14 76 92 00
 1476 9200 1476.9200 14.76.92.00

Decal pinstripes in red and white

 This part is available by special order, request a quote

 17923365 GU17923365 17 92 33 65
 1792 3365 1792.3365 17.92.33.65

Replacement solenoid for original Bosch starter motor.

Note that this solenoid has a bright zinc finsh

 This part is due back in stock soon, call 01484 841395 to reserve yours

 14730554 GU14730554 14 73 05 54
 1473 0554 1473.0554 14.73.05.54

Clutch pushrod for RAM clutch which is 5mm longer than the standard version. This may be needed when fitting a RAM clutch kit to give extra room for adjustment

 1 in stock